Cutting Plywood and Sheet Goods with Kreg's Rip-Cut--by Home Repair Tutor

0
Rip cutting is a popular wood cutting approach in which a workpiece is cut with or along its grain. While this is a generally clean and common wood cutting strategy, rip cutting still requires a few particular actions. To start with, we'll set the most basic basics. All rip cuts need to be carried out with a rip saw blade and a rip fence. The ripping bade ensures smooth, precise cuts and the rip fence helps assist each workpiece and support as it passes through the saw. As with all through cuts, you ought to also utilize your blade guard while rip cutting and although the miter gauge is needed for some methods (like cross cutting workpieces), it ought to not be utilized while making rip cuts.

Through Rip Cuts
Prior to beginning each rip cut, ensure your table saw's motor is off which the saw blade has completely stopped spinning. Next, set the blade to the needed tilt angle and change the blade's elevation to approximately 1/8-inch above the workpiece. After the blade has actually been correctly changed, place the rip fence for your rip width and lock it into location.

NOTE: Remember that serious injuries may happen when ripping operations are tried freehand or incorrectly: if you are not sure about the performance or mechanics of your rip fence, please refer to its handbook. It will be rich with realities, ideas, guidelines or any other details you might be looking for (with regard to your rip fence, at least).

Next, place your workpiece so that the grain faces the saw blade head-on and runs parallel to the rip fence. When pressing a workpiece through the blade, you need to constantly keep at least 6-inches (in every direction) in between your hands and the saw blade.

To prevent positioning your hands too near to a spinning blade, there are a few other positions or techniques you can utilize. If your hand that is outermost from the fence approaches the 6-inch zone, you might either remove that hand entirely and continue the cut with one hand, or you might reposition this hand near your other hand for added support. Eliminate both hands and utilize a push stick (this is typically included with your table saw)if both of your hands approach the 6-inch zone. If your particular cut requires that the rip fence be positioned too close to the blade to utilize a push stick (this may happen where board lengths are very narrow), you may utilize an auxiliary fence and push block to make the cut.

KEEP IN MIND: At the end of this article you will also find directions for utilizing a push and building stick, auxiliary fence and push block.

Continue pressing your workpiece toward the rear of the saw until it clears the blade. Disengage the saw and wait till the blade has come to a complete stop before retrieving the cut-off portion of your workpiece. When rip cutting workpieces that are longer than around 4-feet, utilize rollers, a similar support or an out-feed table system to keep your workpiece from falling off the back of the table.


All rip cuts must be carried out with a rip saw blade and a rip fence. The ripping bade ensures smooth, accurate cuts and the rip fence helps guide each workpiece and support as it passes through the saw. As with all through cuts, you must also utilize your blade guard while rip cutting and although the miter gauge is needed for some techniques (like cross cutting workpieces), it should not be used while making rip cuts.

After the blade has been effectively adjusted, place the rip fence for your rip width and lock it into place.
0Rip cutting is a popular wood cutting approach in which a workpiece is cut with or along its grain. While this is a generally clean and common wood cutting strategy, rip cutting still requires a few particular actions. To start with, we'll set the most basic basics. All rip cuts need to be carried out with a rip saw blade and a rip fence. The ...