Kreg Tool Tip: Simple Ideas for Successful Cuts with the Rip-Cut™

0
Rip cutting is a popular wood cutting method where a workpiece is cut with or along its grain. While this is a typically clean and typical wood cutting technique, rip cutting still needs a few specific steps. We'll lay down the most fundamental essentials. All rip cuts should be carried out with a rip saw blade and a rip fence. The ripping bade ensures smooth, precise cuts and the rip fence assists support and direct each workpiece as it goes through the saw. Similar to all through cuts, you ought to also utilize your blade guard while rip cutting and although the miter gauge is needed for some techniques (like cross cutting workpieces), it needs to not be used while making rip cuts.

Through Rip Cuts
Before beginning each rip cut, make sure your table saw's motor is off which the saw blade has completely stopped spinning. Next, set the blade to the needed tilt angle and adjust the blade's elevation to around 1/8-inch above the workpiece. After the blade has actually been properly adjusted, position the rip fence for your rip width and lock it into place.

NOTE: Remember that major injuries might happen when ripping operations are tried freehand or poorly: if you are uncertain about the functionality or mechanics of your rip fence, please describe its manual. It will be abundant with realities, tips, instructions or any other information you might be searching for (with regard to your rip fence, at least).

Next, position your workpiece so that the grain faces the saw blade head-on and runs parallel to the rip fence. Guarantee the workpiece is flat against the table top and flush versus the side of the fence. Engage the saw and, using both hands, efficiently, steadily press the workpiece towards the blade. When pressing a workpiece through the blade, you need to always keep at least 6-inches (in every direction) between your hands and the saw blade. Any closer is simply too close.

If your hand that is furthest from the fence approaches the 6-inch zone, you might either remove that hand entirely and continue the cut with one hand, or you may reposition this hand near your other hand for added support. If your specific cut requires that the rip fence be placed too close to the blade to use a push stick (this may occur where board lengths are very narrow), you may use an auxiliary fence and push block to make the cut.

KEEP IN MIND: At the end of this short article you will also find guidelines for using a push and constructing stick, auxiliary fence and push block.

Continue pushing your workpiece towards the rear of the saw till it clears the blade. Disengage the saw and wait up until the blade has concerned a total stop prior to obtaining the cut-off part of your workpiece. When rip cutting workpieces that are longer than around 4-feet, use rollers, a similar assistance or an out-feed table system to keep your workpiece from falling off the back of the table.


All rip cuts should be carried out with a rip saw blade and a rip fence. The ripping bade makes sure smooth, accurate cuts and the rip fence assists direct each workpiece and support as it passes through the saw. As with all through cuts, you should also utilize your blade guard while rip cutting and although the miter gauge is required for some strategies (like cross cutting workpieces), it needs to not be used while making rip cuts.

After the blade has actually been effectively changed, place the rip fence for your rip width and lock it into place.
0Rip cutting is a popular wood cutting method where a workpiece is cut with or along its grain. While this is a typically clean and typical wood cutting technique, rip cutting still needs a few specific steps. We'll lay down the most fundamental essentials. All rip cuts should be carried out with a rip saw blade and a rip fence. The ripping bade ensure...